Enabling the 660 performance option
Follow the procedure below to enable the IP performance Option on the 660 Frame relay tester.
- Connect the 660 Frame Relay tester to the Com port on the back of the PC and connect to the 660 Frame Relay Serial port on the side of the unit.
- Make sure the 660 Frame Relay unit is turned on. (To any setting)
- Start the 660 link utility software. (You may have to check the Baud rate settings on the PC and the 660 Frame Relay unit.)
- Select TOOLS from the window tool bar.
- Select OPTIONS.
Select ENABLE OPTIONS. - Enter the Release key in the Key window. (Select IP Performance in the Options window).
- The 660 Frame Relay IP Performance option has now been enabled.
